Construct3D 2017: Full Schedule

12:00pm EDT

OpenSCAD Lunch

Limited Capacity full
Adding this to your schedule will put you on the waitlist.

Grab a lunch and join us for an OpenSCAD learning lunch, and network with other “birds of a feather” who are interested in learning or pushing the boundaries of parametric design. Absolute beginners and seasoned experts are both welcome.

We’ll kick off with a short “Hello OpenSCAD” introduction (bit.ly/1SWeFEF) that will get you up and running in less than 10 minutes while you eat, and have lots of 3D-printed examples of OpenSCAD creations. Then, special guest Marius Kintel, creator of OpenSCAD, will join us by Skype to talk about his development of the software and anything else you’d like to know.

Moderators

Laura Taalman

Speakers

Matthew Griffin

Professor, Ultimaker

Matthew Griffin is the Director of Community for Ultimaker North America. He is currently finishing a lecture series on 3D Printing Hardware for Coursera, a book on design for 3D printing, and is a writer, teacher, and consultant covering topics such as 3D Printing, electronics hobbyists... Read More →

Marius Kintel

Mark Peeters

Tech Director, Comstock Public Schools

I develop 3D printing curriculum for K-12 kids focusing on cross curricular lessons where students get to see their own hand in the printed objects using open source design tools.

Saturday May 6, 2017 12:00pm - 1:00pm EDT
Meeting Room A

Networking, Skill Building, Social Good

Construct3D 2017

12:00pm EDT

Laura Taalman

Matthew Griffin

Marius Kintel

Mark Peeters

Recently Active Attendees